CVO Technical > Intake/Exhaust/ECM
disconnecting power
(1/1)
nixobilly:
Ok, just installed my new thundermax with autotune on my SE2. Have a question about the sticker I'm placing by the battery....
So if I need to remove the + from my battery, I should first remove the ECM fuse from the right hand block and then disconnect the battery....
After reconnnecting my battery, I should do the 30sec on/ 30sec off procedure without touching the throttle......
If i follow these instructions will all the data corrections I have via the autotune be lost or retained?
Thanks,
Mark
jdk20723:
Retained. They are stored within the module, connected to power or not. The only thing you need to do after interrupting module power is re-initialize the system to re-establish IAC and TPS "home" positions. JK
Navigation
[0] Message Index
Go to full version