www.CVOHARLEY.com

Custom Vehicle Discussions => CVO™ Road Glide Custom® => Topic started by: barrhill on April 08, 2020, 10:28:22 AM

Title: ciro 3d frame mounted foot pegs and pingle spacers
Post by: barrhill on April 08, 2020, 10:28:22 AM

has any one done this
I have ciro 3d frame mounted foot peg brackets  would I be able to add pingle 1 1/4 floor board spacers also ?

2019 cvo road glide custom
sorry no pictures bike in shop getting 131 kit

Title: Re: ciro 3d frame mounted foot pegs and pingle spacers
Post by: Mofo67 on April 09, 2020, 03:33:21 AM

If you are using the spacer kit that moves the floorboard out 1 1/4” the answer is yes, but you would have to buy an extra set of spacers. The mount of the Ciro 3D uses two bolts to mount it, the factory only uses one. I did this when I installed my S&S Sidewinder. It uses a similar spacer and I simply bought and extra kit and did the Ciro 3D install without issue.

Title: Re: ciro 3d frame mounted foot pegs and pingle spacers
Post by: barrhill on April 10, 2020, 08:38:19 PM

thanks

Title: Re: ciro 3d frame mounted foot pegs and pingle spacers
Post by: DOCGSS on April 11, 2020, 07:15:43 AM

Quote from: Mofo67 on April 09, 2020, 03:33:21 AM

If you are using the spacer kit that moves the floorboard out 1 1/4” the answer is yes, but you would have to buy an extra set of spacers. The mount of the Ciro 3D uses two bolts to mount it, the factory only uses one. I did this when I installed my S&S Sidewinder. It uses a similar spacer and I simply bought and extra kit and did the Ciro 3D install without issue.

I have done this. I did not buy a second set of spacers, I bought a nut for a half inch bolt that was a half inch thick. You could not see it and it worked out fine. I had to buy new bolts also as they were not long enough. I love the setup.