www.CVOHARLEY.com

CVO Technical => Twin Cam => Topic started by: Joel on June 24, 2023, 10:42:20 PM

Title: Bolt Torque Specs
Post by: Joel on June 24, 2023, 10:42:20 PM

I have been looking for engine bolt torque specs and not seeing anything here on this forum.
I have a 2015 Limited with the 110 and in the process of replacing the cam bearings and lifters,
I had a pdf with the repair and torque info but somehow lost it.
If you have the info I would appreciate it if you could post it here for me. Thanks

Title: Re: Bolt Torque Specs
Post by: TN on June 25, 2023, 06:41:23 AM

2015 touring models.

Title: Re: Bolt Torque Specs
Post by: Joel on June 25, 2023, 09:32:25 AM

Thank you,  that is very helpful.
Now if I can only find the service manual I had on that pdf I downloaded a few months ago when I bought my lifters and gaskets .
After going the route I did to save push rod tubes I see why some choose to go with adjustable push rods.
But I wanted to get the experience, and today I'll be removing and installing the new cam bearings.

Title: Re: Bolt Torque Specs
Post by: TN on June 29, 2023, 03:55:39 PM

Joel, you can find lots of info on the HD-SIP portal. It takes some time to get familar with navigating thru the site, lots of info is available if you take the time to do so.

I have heard that facebook has some manual sharing groups available also, I have no experience with them.

Good luck with your project

https://serviceinfo.harley-davidson.com/sip/index