Custom Vehicle Discussions > CVO™ Breakout™

Quadlock wireless charger installation

(1/1)

2014CVO:
Hi guys/girls/others,
Seeking your help please.
I purchased a Quadlock wireless charger and I’m trying to locate the best place to wire it.
Is there a live wire and earth wire connection this can be easily connected to? (Possibly near handlebars or under the seat?)
On my previous Harley, I connected this to the headlight wire inside the headlight, but I had to drill a small hole in the headlight to pass the wire through. However, I don’t want to drill any holes in my 2014 CVO Breakout headlight.
Is there an accessory cable/connector on the breakout that has live and earth cable where the live wire only has power when the bike is switched on?
I know I can connect directly to battery terminals, but as this drains the battery, would prefer to connect to a cable that is only live when the bike is ON.
Your help is very much appreciated, thank you.

2014CVO:
782 views, but not one bit of advice or help. I’m not an electrician, was hoping for guidance.  :-X I will connect to the rear tail light cables and pray I don’t burn the bike down. Almost finished the oil can, waiting for new gaskets and o rings from dealer. The breather bolts look chit and don’t suit a CVO…wish they were chrome..might have to polish them before I reinstall everything. Rear tail lights (US domestic) and custom dynamics lights arriving soon. 80% of bolts on bike replaced with chrome bolts. Rear tail bag and saddlebags ready to go, just need to install Chopz tail tidy first.

2014CVO:
Quadlock charger installed and working…connected to licence plate light at Deutsch connector. Relatively simple connection.

Navigation

[0] Message Index