CVO Technical > Intake/Exhaust/ECM
M8 Ventilator upgrade
rayson56:
Looking for a way to get more air to our M8's I found a K&N filter that has almost twice as much material that came close but is not an exact fit for our Ventilators.
rayson56:
.
rayson56:
The base of the new filter is a little bigger than the stock element so I had to relieve the edging on the top 2/3 of the backing plate.
rayson56:
Then I needed to drill a couple of holes in the new element to line up for my housing. I glued a couple of rubber grommets on the new element to replicate the rises that the stock element has surrounding the mounting holes. (forgot to take pics) I also installed a bolt in the back side of the center hole to keep it from pulling air through it.
rayson56:
So with a little finagling here is the finished product.
Navigation
[0] Message Index
[#] Next page
Go to full version