Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[VaEagle]

Fired00d is correct on the part number for the Rear Bumper light Kit LTbawb it is #92091-03.
You will also need part number #91023-79 which is the rear bumper rail itself. I don't remember how much it was though.
If you don't go any further you should be fine but I also got the nostalgia saddlebag rails and had to get the chrome slotted filler strips to fit the rails. I don't think you will need to change filer strips if all you want is the rear bumper rail and LED light.

[2006_CVO_HD]

I see more stuff that I need to purchase and install......

[HogDude]

I see more stuff that I need to purchase and install......

2006- It's only money....... go for it 

[CVOwner]

I wondered if that covered the emblem too.  Looks great, I ended up with the Street Glide option just before the MoCo released the OCD version for the bikes.

Love them both,    I think I may remove the emblem as well, looks cleaner without it, IMO.

Did they have to drill holes in your fender on the side to install that? The street glides I have looked at looked like they had to be attached by drilling holes in the side, 3 on each side. Whats up with that? I like the look, but dont want to be drillin holes.

[RJ749]

Did they have to drill holes in your fender on the side to install that? The street glides I have looked at looked like they had to be attached by drilling holes in the side, 3 on each side. Whats up with that? I like the look, but don't want to be drillin holes.

No drilling into the SEUC.  The piece actually has a clip fit at the bottom of the fender and the rest of the sides were installed using 3M double stick tape as mentioned earlier here or in another thread.  It is a pretty simple addition and does not require drilling when the tape is used.

I have 800 miles through the rain and wind etc. and all appears normal.

[06cvo]

I really like the street glide look, did it match the paint on your bike.