www.CVOHARLEY.com

CVO Technical => Milwaukee-Eight => Topic started by: CJ CYCLE on September 24, 2018, 09:43:23 PM

Title: This Happens if you don't disarm your CVO before service
Post by: CJ CYCLE on September 24, 2018, 09:43:23 PM

Working on my handlebar install and was replacing a micro connector in the right handlebar controls and crossed a couple wires.  The siren went off and nothing I could do would stop it including pulling the main fuse and disconnecting the battery.  After about 5 mins. of piercing alarm, it stopped.  When I was ready to start it up, the bike was completely dead.  No power.  Finally checked the fuse box.  The "battery" fuse was blown.  Replaced it and it started right up. 

CJ

Title: Re: This Happens if you don't disarm your CVO before service
Post by: BUCKNUT GREG on September 24, 2018, 10:17:53 PM

  Ahhh you need to read your manual for working on bike when playing with electrical connections.  WOW