Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Puzzled]

287

[Puzzled]

288

[Puzzled]

No wires or lines running down the bars.

[rayson56]

Very nice and clean. If you can use another set of those bars let me know Mike.

Kelly

[Puzzled]

I learned a little something today....

I went to put power to the bike today and had limited power. My first thought is what did I touch that caused this? I started checking wires for power and power was present. My grounds were good. My fuses were good. Why don't I have gauges, radio and headlight? I removed most of the unneeded wiring by simply unplugging them with the exception of 10 wires. 3 pairs of canbus wires from the amps, 3 power wires and one ground all from the amps. I broke out the wiring diagram and started reading. The canbus is looking for 3.5 volts. All of the parts hooked to canbus use the same color wires. Looking at the diagram and following all of the wires they are all looped together. I broke the loop in two places so I attached those three sets of wires back into the loop. WE HAVE POWER! I may have some codes from breaking the loop however I should be able to clear them and be good to go.

[DesertHOG]

I learned a little something today....

I went to put power to the bike today and had limited power. My first thought is what did I touch that caused this? I started checking wires for power and power was present. My grounds were good. My fuses were good. Why don't I have gauges, radio and headlight? I removed most of the unneeded wiring by simply unplugging them with the exception of 10 wires. 3 pairs of canbus wires from the amps, 3 power wires and one ground all from the amps. I broke out the wiring diagram and started reading. The canbus is looking for 3.5 volts. All of the parts hooked to canbus use the same color wires. Looking at the diagram and following all of the wires they are all looped together. I broke the loop in two places so I attached those three sets of wires back into the loop. WE HAVE POWER! I may have some codes from breaking the loop however I should be able to clear them and be good to go.

Houston, we have ignition.

[Puzzled]

This is what I have to work with.

[Puzzled]

Another.. what I'm trying to show is the usable space in the fairing.

[Puzzled]

I need to get all of that in the space you don't see!!

[Puzzled]

Since the small amps are limited in regards to their tuning abilities I'll be using this to clean up the sound.

[Puzzled]

The audio control and two amps under the radio tray. The other two will go on top of the headlights. I cut all of the mounting tabs off of the audio equipment to make everything as small as I could. It all fit without the wiring attached. Next up is to start running the wiring...

[rayson56]

Looks kinda familiar Mike.....

https://fansinaflashbulb.wordpress.com/2013/01/17/phone-booth-stuffing/

[rayson56]

That tab is located in the handlebar clamp. It has to be removed to allow the brake line to be run through the handlebar.

Just removed the tab/peg in mine today just to get more adjustment for the controls on the new bars. Makes all the difference. Thanks for the insight!

[Puzzled]

Looks like I'm going to be busy.....

Several parts are due to arrive tomorrow according to UPS.

Picking up the painted parts over the weekend.

UPS says more parts will be arriving Monday.

That should be everything unless I run into something I forgot....

I do want to add an air pressure gauge once I figure out where I'm going to install it.

I scheduled off some work the beginning of February with hopes to spend that time finishing up the bike.

[Puzzled]

295