Hello guys
I just got my 2018 limited, as this is HDI it came with a lousy red run/brake tour pack wrapping, I liked a lot the US smoked light so I was planning on buying the 67800368 and maybe paint it.
Then 'ebaying' I found one that came from a CVO (don't know the year, and I couldn't found anywhere the number is stamped on the back of it 67800566DXM), I decided to purchase it to repaint it later.
As soon as I got it I tried it on the bike, it works but not as I expected.
On run, the three sections light (that is Ok)
On turn signals, the corner lights brighter (that is Ok also)
But on brake, only the center section lights (don't know if that is Ok)
I was reading the installation guide from the 67800368 and it states that's the way it actually works, but I think I've seen the US bikes light all the three sections on brake (maybe newer models?, and extra module?, different wiring?).
As I told you, mine is HDI so it came with the turn signal/light bar on the fender (just like the 2014 but with LED). Maybe that requires a different wiring?
I could use some of your experience on this matter, to figure if I can make the turn signals act as brake lights as well, of maybe that is the way 2014 used to work.
I appreciate any feedback