Please login or register.

Login with username, password and session length
Advanced search  
Pages: 1 2 [3] 4  All

Author Topic: start without fob HELP!!  (Read 10009 times)

0 Members and 1 Guest are viewing this topic.

bradthomas1965

  • Newbie
  • *
  • Offline Offline
  • Posts: 37
  • www.CVOHARLEY.com
    • WA


    • CVO1: 2013 Road king
    • CVO2: 2001 wideglide
Re: start without fob
« Reply #30 on: October 18, 2018, 07:57:39 PM »

Oh trust me, i did that....many times. Like i said before, tried holding them in.
When i do that, alarm does chirp once, will chirp again sec or two later & a few more seconds, full on alarm. Again, speedometer never shows or gives oppurtunity to in put code!!!  :soapbox:
Starting to believe my HFSM/TSM could be faulty. Maybe module was never programmed all the way? Defect from module manufactuerer??
Just curious, & maybe it doesnt matter, but do any of you have the same speedometer/tach that i do??? I havent seen any other bikes with the same as mine.
« Last Edit: October 18, 2018, 08:01:28 PM by bradthomas1965 »
Logged

bradthomas1965

  • Newbie
  • *
  • Offline Offline
  • Posts: 37
  • www.CVOHARLEY.com
    • WA


    • CVO1: 2013 Road king
    • CVO2: 2001 wideglide
Re: start without fob
« Reply #31 on: October 18, 2018, 08:13:45 PM »

Logged

KGB

  • 1K CVO Member
  • *
  • Offline Offline
  • Posts: 1230
  • www.CVOHARLEY.com
    • OH


    • CVO1: 2016 FLHXSE Carbon Crystal with Phantom Flames
    • CVO2: 2019 FLHTKSE Magnetic Grey/Wineberry w Red Pepper
Re: start without fob
« Reply #32 on: October 18, 2018, 08:18:02 PM »

Check to see if you have any fault codes
Logged
2018 MITM Eureka Springs
2018 WV GTG
2018 Maggie Valley GTG
2019 MITM Eureka Springs
2019 Maggie Valley GTG
2020 Maggie Valley GTG
2021 WV GTG
2021 Maggie Valley GTG
2022 Ohio GTG
2023 1/2 Maggie Valley GTG

Cat Eye

  • 1K CVO Member
  • *
  • Offline Offline
  • Posts: 1389


    • CVO1: 2015 FLHXSE
Re: start without fob
« Reply #33 on: October 18, 2018, 08:53:27 PM »

Yes Jerry, I tried "on off on off on" then turn signals.  Alarm beeps instantly. Thanks but still nothing.

The above procedure is to reprogram the pin and the FOB need to be in range.
Logged

bradthomas1965

  • Newbie
  • *
  • Offline Offline
  • Posts: 37
  • www.CVOHARLEY.com
    • WA


    • CVO1: 2013 Road king
    • CVO2: 2001 wideglide
Re: start without fob
« Reply #34 on: October 18, 2018, 09:35:48 PM »

Checked fault codes, no stored fault codes in any of the programs.... ran code throuh all checks  P55Ptb    none on any of them
Logged

14 CVO King

  • Newbie
  • *
  • Offline Offline
  • Posts: 43
  • www.CVOHARLEY.com
    • WA


    • CVO1: 2019 FLTRXSE
    • CVO2: 2014 FLHRSE
Re: start without fob
« Reply #35 on: October 18, 2018, 10:50:28 PM »

Try this, flip the ignition and watch the ODO. if you see the word ENTER appear hit the left turn signal.  If this works a 1 should show up.  If that does not work try pausing a second between turning on the ignition and holding the turn signals.

Honestly, my RK was a pain in the backside and the last time i left without the fob I had to have the wife bring it out to me.  I could get it to work for me in the garage but hit or miss on the road.  I do practice now a lot and wonder if your bike works like the newer models rather then the regular alarm of a 13.
Logged

bradthomas1965

  • Newbie
  • *
  • Offline Offline
  • Posts: 37
  • www.CVOHARLEY.com
    • WA


    • CVO1: 2013 Road king
    • CVO2: 2001 wideglide
Re: start without fob
« Reply #36 on: October 18, 2018, 11:20:12 PM »

At this point, ill try anything. Ill try it like a 14 & newer
Logged

bradthomas1965

  • Newbie
  • *
  • Offline Offline
  • Posts: 37
  • www.CVOHARLEY.com
    • WA


    • CVO1: 2013 Road king
    • CVO2: 2001 wideglide
Re: start without fob
« Reply #37 on: October 19, 2018, 10:59:00 PM »

2014 & newer says turn IGN on then push & hold LEFT turn signal.
Tried this as well.....no luck
Tried turning just ignition, no luck either...... alarm goes off after a couple chirps & sirens
both ways.....every way!!!
2014 & older & 2014 & newer procedure... ive tried all.
Itll be a good story if i EVER figure it out !!!
Logged

grc

  • 10K CVO Member
  • ****
  • Offline Offline
  • Posts: 14216
  • AKA Grouchy Old Fart
    • IN


    • CVO1: 2005 SEEG2
Re: start without fob
« Reply #38 on: October 20, 2018, 08:45:41 AM »

...............................................
Starting to believe my HFSM/TSM could be faulty. Maybe module was never programmed all the way? Defect from module manufactuerer??
Just curious, & maybe it doesnt matter, but do any of you have the same speedometer/tach that i do??? I havent seen any other bikes with the same as mine.

What you have sure looks like the one shown in the parts catalog for the 2013 CVO RK.  Standard RK's did not come with that same gauge and console setup, so unless you compare just to other CVO's it won't be the same.

Jerry



Logged
Jerry - 2005 Cherry SEEG  -  Member # 1155

H-D and me  -  a classic love / hate relationship.  Current score:  love 40, hate 50, bewildered 10.

bradthomas1965

  • Newbie
  • *
  • Offline Offline
  • Posts: 37
  • www.CVOHARLEY.com
    • WA


    • CVO1: 2013 Road king
    • CVO2: 2001 wideglide
Re: start without fob
« Reply #39 on: October 21, 2018, 01:58:12 PM »

It is Jerry. & it is factory. Just curious if any other 2013 cvo rk people have similar issues.
Thanks for the input.
Logged

bradthomas1965

  • Newbie
  • *
  • Offline Offline
  • Posts: 37
  • www.CVOHARLEY.com
    • WA


    • CVO1: 2013 Road king
    • CVO2: 2001 wideglide
Re: start without fob HELP!!
« Reply #40 on: November 19, 2018, 10:31:19 PM »

STILL NOT WORKING!!!! :soapbox:
Logged

skratch

  • 1K CVO Member
  • *
  • Offline Offline
  • Posts: 2003
    • LA

    • CVO1: 2013 FLTRXSE2 Roman Gold/Burnt Emerald
Re: start without fob HELP!!
« Reply #41 on: November 19, 2018, 11:19:04 PM »

have you tried going by the dealer?  let them try it, one of two things will happen.  they'll either get it to work, at which point you will have seen the process.  or, it won't work, and you'll end up getting a new hfsm for $50  (you do have the esp don't you?)

out of curiosity, does the security keep the bike from starting if you are not within range with a fob?
Logged
I understand the concept of reality, but find it too confining as a way of life

bradthomas1965

  • Newbie
  • *
  • Offline Offline
  • Posts: 37
  • www.CVOHARLEY.com
    • WA


    • CVO1: 2013 Road king
    • CVO2: 2001 wideglide
Re: start without fob HELP!!
« Reply #42 on: November 19, 2018, 11:28:05 PM »

Yes, purchased extended warranty.( So glad, cam went to chit with only 16,000 mi).
& correct,  it won't start without fob in range.
I've tried everything,  so I'm thinking you're right,  I'll run it by Harley.
Logged

bradthomas1965

  • Newbie
  • *
  • Offline Offline
  • Posts: 37
  • www.CVOHARLEY.com
    • WA


    • CVO1: 2013 Road king
    • CVO2: 2001 wideglide
Re: start without fob HELP!!
« Reply #43 on: November 19, 2018, 11:31:41 PM »

Interesting,  when I had it in the shop for the new cam, mechanic told me 4 other bikes where in with bad cams!!
Logged

skratch

  • 1K CVO Member
  • *
  • Offline Offline
  • Posts: 2003
    • LA

    • CVO1: 2013 FLTRXSE2 Roman Gold/Burnt Emerald
Re: start without fob HELP!!
« Reply #44 on: December 31, 2018, 10:05:02 PM »

but, what about the fob start thing?
Logged
I understand the concept of reality, but find it too confining as a way of life
Pages: 1 2 [3] 4  All
 

Page created in 0.214 seconds with 22 queries.