Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[NE-Tacoma06Fatboy]

where did you get these bars from

[fatboyse2]

The Bombay bars will fit with the hydraulic clutch but you will need to adapt the clamp and drill one hole.

[AUSSIE_FLSTFSE]

where did you get these bars from

They come from downunder in my neck of the woods.

www.customcyclesupply.com.au

Cheers
Aussie

[AUSSIE_FLSTFSE]

Mike, They are very similar to yours, I think they are taller. The bar from Center of the top to center of the piece that goes through the clamp is [highlight]10 3/4.[/highlight] Outstanding quality, they do have some welds but very little, they polished most of them completely away. I took the clamp off, removed the old and set them in and tightened them just to eye it up, I have good vision of the tach from 1500 to 6500... I am really excited thanks for the connection... Pics to follow.. I have my Corbin Hollywood solo on also so It will be a multiple change post..

That seems quite high Jim, I hope your brake hoses are still long enough.

Cheers
Aussie

[tunedse2]

That seems quite high Jim, I hope your brake hoses are still long enough.

You and me both Mike, They have the curl back like yours so Im hoping for the best, I give you a bad measurement its 9 3/4, still pretty high. My grips end up about 2 inches higher and 1inch inside the stock bars. It gets picked up Monday so not long to wait.

[NE-Tacoma06Fatboy]

The Bombay bars will fit with the hydraulic clutch but you will need to adapt the clamp and drill one hole.

can you expand on that a bit?    I am very interested in doing these bars if it does not entail too much mods.  I have a guy that wrenches for me and his going rate is much cheaper than HD but still...

[tunedse2]

Finally back. Bar pics as promised. Also featured is the new hollywood solo and the flush mount fuel gauge and cap.

[tunedse2]

another

[tunedse2]

another

[tunedse2]

one last shot of the Bars- Custom made in Australia.

[NE-Tacoma06Fatboy]

would you have the measurements on the bars as well as did you need any new cables?


I am jealous.... nice stuff.

[tunedse2]

 No new cables. 31" corner to corner. 9 3/4" top to bottom.

[NE-Tacoma06Fatboy]

do you mind if I ask where you got these from and what you paid for them?

[tunedse2]

custom cycle supply in Australia. They custom made them for me.. go up 4 or 5 posts Aussie left you the link.

[NE-Tacoma06Fatboy]

Oh!   I thought it was a different supplier.  Thanks.   I may go that route if I cannot figure out something.  Everything I see is not hydrualic clutch compatible.  Makes me wonder why the MOCO does not get us one that is...