Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[JCZ]

To JCZ; I’ve got a 328M Grand Design Toyhauler.
How did you access the underside if your RV to fasten the plates? Did you cut through the layers of underbelly stuff to get to the floor?
Thanks, COB

On the 376TH the garage floor is not sealed underneath like the rest of the RV so it was very easy.  I'm not sure about the 328M......if it has the coroplast under your garage, maybe you can just drop that one section and then put it back up after the Biker Bar is installed.

[BigLew]

For some reason when I load mine there is a greater than 75% That the left side will lock but the right side will not then it becomes a rear hassle. Cant figure if its the ride height if the bike is a little sideways, or if there is something wrong with the brace?

BigLew

[wtfdskin]

For some reason when I load mine there is a greater than 75% That the left side will lock but the right side will not then it becomes a rear hassle. Cant figure if its the ride height if the bike is a little sideways, or if there is something wrong with the brace?

BigLew

Im guessing you're a bit sideways. I have that issue now and then. It only takes being a little bit off.

[BigLew]

Sure causes a lot of issues!

BigLew

[wtfdskin]

I've been sideways and a little off all my life

[BigLew]

Wow the kinder gentle me is going to leave that alone. But I understand!. You are unique.

BigLew

[08glide]

Hey Mike, just get it straight.     is this the same bar that (maybe got a little bent) when your bike fell over?

[BigLew]

got a new bar the old one was beyond use. I wonder if the mount is damaged?

BigLew

[JCZ]

got a new bar the old one was beyond use. I wonder if the mount is damaged?

BigLew

Sounds like it might be.  Give B&W a call....I believe they have good customer service.