www.CVOHARLEY.com
CVO Technical => Intake/Exhaust/ECM => Topic started by: Paulgta on March 13, 2023, 10:02:45 PM
-
Hey guys doing some work on the bike and noticed both bolts that hold crossover pipe bracket to oil pan are broken flush. I have welding nuts on car heads to get broken studs out any one have this problem and solutions with out replacing the upper oil pan ?
-
I start with PB Blaster, letting it soak overnight.
Center punch the stud, cause it's no longer a bolt, I put electrical tape on the bit to mark a max depth.
I use a small diameter left hand drill bit to make a pilot hole, moving the size up.
Sometimes I get lucky and the bit grabs the stud and unthreads it, if not then its time for an easy out.
If it is stubborn you can heat around the stud and then install the easy out and try again.
-
If KROIL won't do it, get the drill jig out. ::)
John
-
I had to do mine on the 2012 CVO. I used an ez out but it is tough to get to laying in the floor!!