www.CVOHARLEY.com

CVO Technical => Drive Train => Topic started by: sammyj on January 11, 2011, 02:10:20 PM

Title: Barnett Scorpion Clutch
Post by: sammyj on January 11, 2011, 02:10:20 PM

Any feedback from anyone that's installed this clutch set up?

Title: Re: Barnett Scorpion Clutch
Post by: Twolanerider on January 11, 2011, 02:39:35 PM

Got it on both bikes.  I'm satisfied. 

Title: Re: Barnett Scorpion Clutch
Post by: 06fastboy2 on January 18, 2011, 09:46:52 PM

Anyone know the torque rating on these clutches,I'm building 114's for both my 06SEFB and 05SEEG.

Title: Re: Barnett Scorpion Clutch
Post by: Twolanerider on January 18, 2011, 11:45:59 PM

Quote from: 06fastboy2 on January 18, 2011, 09:46:52 PM

Anyone know the torque rating on these clutches,I'm building 114's for both my 06SEFB and 05SEEG.

Haven't seen a published spec from the manufacturer.  Of course the spec would vary a bit since overall force against the clutch would involve not just engine output but bike weight.  As a strictly anecdotal reference the unit in my 05 works fine behind an engine that outputs around 120/120.  And of the various strenght springs they provide to adjust clamping force I'm only using the mid-range.