Hey Pork - Here is a closer picture of the mounting hardware. What I mean by "flipping the gromet" is that I can remove the chrome button head bolt from the top of the mounting hardware for the passing light, and take off an aluminum machined bushing "basically a spacer I made to accept the mounting hardware for the passing lights", I also take off the rubber gromet "this is the part where the windshield snaps over" and swap places with the machined bushing and the rubber gromet. In the picture you will see that the rubber gromet on the top is next to the forks. By swapping places with the machined bushing and placing the machined bushing next to the forks, and the rubber gromet closer to the mounting hardware for the passing lights, and I can use a standard HD windshield, instead of the CVO windshiled. I can only do this because I created an independent mounting hardware for the passing lights that allows me to change the position of the hardware, because the hardware on the right and left side is not fixed with a connecting bar. Clear as mud??