www.CVOHARLEY.com

CVO Technical => Electronic Toys and Gadgets => Topic started by: jvanderpool on February 13, 2018, 02:42:53 PM

Title: Power Lock Buttons Not Working.
Post by: jvanderpool on February 13, 2018, 02:42:53 PM
Hello All,

I have a 2016 CVO Limited.  I doubt the issues are related, but in the last month both the rear TPMS has stopped reading and the power lock switch on the dash has stop working.  Of course it is just a few months past the warranty.  Focusing on on one issue at a time, I will start with the locks.  Both the lock and unlock work perfect for all three boxes and the forks when you use the FOB.  However, neither work from the dash switch.  The lights on the buttons themselves light up fine but nothing else happens.  The head/tail lights do not blink and the horn does not chirp.  I have even changed out the switch with no luck.  I just wanted to see if anyone had any advice before I take it to a dealer.  Thanks a  million in advance for any advice.     
Title: Re: Power Lock Buttons Not Working.
Post by: havenolife on February 14, 2018, 11:20:15 AM
stick your key in the ignition switch and play with it lock unlock a couple times then make sure its all the way to normal and see if that will help it worked for me i must have not turned it all the way back to on with the key try it and see   
Title: Re: Power Lock Buttons Not Working.
Post by: muddypaws on February 14, 2018, 12:08:39 PM
New battery, Mine did the same thing.
Title: Re: Power Lock Buttons Not Working.
Post by: jvanderpool on February 15, 2018, 03:25:06 PM
Thank you both for your responses.  I tried working the lock manually with key several times.  No luck. 

The battery is only about 2 years old and holds a consistent charge.  The bike fires right up without an issue even after sitting for a week.  I figured if it had battery issues it would be hard to start.  Also I would think that while the bike is running the alternator would overcome a weak battery and the locks would work.  I could be 100% wrong, but it defies the normal logical signs of a weak battery.

I really appreciate the help.

JR
Title: Re: Power Lock Buttons Not Working.
Post by: grc on February 15, 2018, 04:04:05 PM

Have you traced the wires back to the module to make certain they are connected and not broken?  You indicated you already changed the switch, but if there is a terminal pushout or a broken wire in the circuit that could account for the backlight for the switch working but not the actual locks. 

Jerry
Title: Re: Power Lock Buttons Not Working.
Post by: muddypaws on February 15, 2018, 08:42:24 PM
Battery in the FOB. When I picked up my new bike one of the FOB batteries was just about dead.
Title: Re: Power Lock Buttons Not Working.
Post by: Fired00d on February 15, 2018, 09:30:52 PM
Battery in the FOB. When I picked up my new bike one of the FOB batteries was just about dead.
Don't think that's the case here from what was stated in the original post...

Hello All,

I have a 2016 CVO Limited.  I doubt the issues are related, but in the last month both the rear TPMS has stopped reading and the power lock switch on the dash has stop working.  Of course it is just a few months past the warranty.  Focusing on on one issue at a time, I will start with the locks.  Both the lock and unlock work perfect for all three boxes and the forks when you use the FOB.  However, neither work from the dash switch.  The lights on the buttons themselves light up fine but nothing else happens.  The head/tail lights do not blink and the horn does not chirp.  I have even changed out the switch with no luck.  I just wanted to see if anyone had any advice before I take it to a dealer.  Thanks a  million in advance for any advice.     

 :pumpkin:
Ride Safe,
Fired00d
 :fireman: