www.CVOHARLEY.com

Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: Coolant lines  (Read 1043 times)

0 Members and 1 Guest are viewing this topic.

LMR

  • Junior CVO Member
  • **
  • Offline Offline
  • Posts: 76
  • www.CVOHARLEY.com
    • CT

Coolant lines
« on: April 10, 2018, 09:51:22 PM »
On a twin cool bike, the metal tubes at the top that go into the connector, how far do the tubes push in ? Should the ridge be showing or does it go any further?
Logged

LMR

  • Junior CVO Member
  • **
  • Offline Offline
  • Posts: 76
  • www.CVOHARLEY.com
    • CT

Re: Coolant lines
« Reply #1 on: April 11, 2018, 05:38:55 PM »
I was able to use a pair of channel locks and they popped right in.
Logged

bakon

  • Elite CVO Member
  • *****
  • Offline Offline
  • Posts: 573
    • PA


    • CVO1: 2014 CVO Limited "Wicked"
Re: Coolant lines
« Reply #2 on: April 11, 2018, 07:20:03 PM »
Did you loosen the screw and hold em in clamp?  They are held in to the manifold by a screw and semi clampy thingamadoo.
Logged
Will

LMR

  • Junior CVO Member
  • **
  • Offline Offline
  • Posts: 76
  • www.CVOHARLEY.com
    • CT

Re: Coolant lines
« Reply #3 on: April 11, 2018, 09:27:31 PM »
After setting the flange in the pipe, it made a lot more sense for it to be flush so the clamp can hold it in place. My last bike was an 06 so some new stuff I have to learn about . Some tough spots but has been fun building so far. I am an amateur with just enough knowledge to get me in trouble.
Logged
 

Page created in 0.112 seconds with 21 queries.