Was it quick and easy install?
I installed one the other day. Super quick and easy. Only had a couple issues.
1. The wiring sheathing was too thick to fit back into the rear fender struts. And with the removal of the rear brake light structure, there is no clean way to mount the wiring back to the seat. I had to use 3m tape and so far so good (other than it looks bad if you look up under the rear fender).
2. The epoxy has a super quick life cycle. Mix it fast and apply it under 3 minutes. The good thing about it tho, there is plenty of epoxy if you don't get it right the first time.
I would highly recommend not just peeling it and sticking it. Make sure you position it correctly. This light will be painfully difficult to remove once installed.
I do have to say the electrical connector are super fantastic.