Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[newseultra07]

Update. Got the cam bearing out and replaced with new one. I’m using a knock off Tool I got off eBay and i turned when installed bearing till it bottomed out and couldn’t turn no more. I measured the original bearing depth before removing and when I installed new bearing it’s just a fraction not as deep hope won’t be a problem.

[J.D.]

No problem.

[Yellow09SERG]

I’m using new lifters. Ones I’m pulling out only have 3000 miles on them but since was opened up may as well change them.  So I can just drop them in then without filling with oil. ??

I have had pretty good luck filling them with a syringe held against the feed hole. Just push the oil till it come out the top.

[HD Street Performance]

I use a Mason jar with a bulkhead fitting on the top. Use my vacuum pump on the serdi to pull the jar down until there are no more bubbles.

[newseultra07]

Well had problems with pushrods. Got frustrated so just took bike down to indy shop to finish it up.. I didn't want to damage anything starting up & it not being correct..

[J.D.]

What problems out of curiosity?

[newseultra07]

Just couldn't get my fingers in there to adjust them correctly. I wasn't using S&S Quickies either. Didn't want to fire it up & there be something out of adjustment & then Kaboom...