Custom Vehicle Discussions > Screamin’ Eagle® Dyna® Fat Bob

Removal of Real Passanger Peg on CVO Dyna Fatbob

(1/1)

StevieMo:
I have a new '09 Fatbob CVO that I will only ride solo.  I want to get a single passenger seat and remove the rear foot pegs.  The belt side is the probem as the "chain" guard shares a support that is part of the peg.  Anyone have any ideas of how to keep the factory chain guard but remove the peg?  Thanks, Steve

Fired00d:
StevieMo,
I can't help you w/your question, but hopefully another SEDFatbob owner will be able to. However I would like to welcome you to the site. When you get a chance you should go to this board - New Member Introduction and start a thread to introduce yourself.

 :pumpkin:
Ride Safe,
Fired00d
 :fireman:

cowboy7123:
I would love to help you bro, But my wife will be on the back of mine.. not much but she will be.

dirtyoldman:
I didn't even realize that was the set up til i lookes at mine. after looking at the 'bracket used to mount the midsection of my pipes,,, should be a simple enough trick to fab a similar bracket. seems a simple L bracket would do the trick, but maybe a flanged bracket can be hidden by the guard save for flange to the frame. And powdercoat finish,,   Hmmm,,   

dirtyoldman:
some thing hit me last nite going thru parts catalog.  some passenger items list passenger pegs and mount as a required accessory,,,,  well,, if those Bobs dont have stock pegs and mounts,,, what are they replacing? I haven't seen a Bob w/out pegs yet, maybe the original equipment mount for a solo setup would fit. hmmm,,

just a thought,,,   

Navigation

[0] Message Index