www.CVOHARLEY.com
CVO Technical => Trailers / toyhaulers => Topic started by: fkjunkin on September 15, 2019, 11:48:29 PM
-
Bought a Bushtec hitch for my 2011 FLTRUSE from a poster here and after install it hangs down approx 3 inches below fender, looking to fill the gap with perhaps a mudflap or some type of panel but having a bit of difficulty finding an off the shelf solution.
any ideas?
-
I had the Bushtec hitch for my '11 FLTRUSE, and if I removed the draw bar (with hitch pin attached) it barely showed below the fender. Not sure why yours shows.
-
At work right now and dont have pic but the hitch plate is 3 inches below bottom of fender. Obviously incorrect hitch but it is bought and installed so filling the gap is better than starting over for me.
-
Put a rear fascia with the tri bar light in it to fill that gap.
-
Exactly what I am looking for, thanks
-
Bet what you bought is the V3 hitch which is made for the bikes with the gascia.
-
You would apparently be correct sir