www.CVOHARLEY.com
CVO Technical => Drive Train => Topic started by: flhrse4 on June 03, 2020, 08:07:40 PM
-
Tried bleeding clutch and that didn't work then tried a reverse flush would not allow fluid in. Then tried to bleed master cylinder when I loosened bango bolt I didn't have any air or fluid leaking, so I pulled out the whole bango bolt and still no fluid came out of line. I am at a loss as to what is going on, or how to proceed next. Do not want to pull exhaust to remove and look at secondary actuator if the problem is coming line. Was thinking about doing a reverse flush with bango disconnected to see if fluid was going through and problem might be with piston in master cylinder. Any help or advise would be appreciated.