Topic: Power vision (Read 781 times)

bubtrauma · « **on:** June 16, 2019, 12:45:06 PM »

Hi guys,
I have a powervision and I seem to have lost two screws that the mounting bracket bolts to but can't seem to find the right thread pitch. I measured them and seem to need 36 pitch?

Any comments would be appreciated.

IA17RGU · « **Reply #1 on:** June 16, 2019, 02:40:42 PM »

Best I could say is take one out and go to Lowe’s? Fastenal?

Sent from my iPhone using Tapatalk

Unbalanced · « **Reply #2 on:** June 16, 2019, 06:50:11 PM »

Have you called DynoJet customer service?

You might also try Daytona Nut and Bolt as another source

http://www.daytonabolt.com/index.html

vtwinjim · « **Reply #3 on:** June 16, 2019, 11:51:26 PM »

If your talking about the u shaped bracket, mine seems to be 10-32 or .190-32
But I was able to insert a 5mm x .8mm thread pitch metric screw
10-32 will typically fit into 5mm x .8mm thread pitch so it could be metric
.8mm pitch = 31.75 TPI
5mm = .197 inch

Author Topic: Power vision (Read 781 times)

bubtrauma

Power vision

IA17RGU

Re: Power vision

Unbalanced

Re: Power vision

vtwinjim

Re: Power vision