www.CVOHARLEY.com
Custom Vehicle Discussions => Screamin' EagleĀ® Road KingĀ® => Topic started by: caymanjack on September 29, 2005, 07:46:54 PM
-
I want to put the wire harness that runs to both the right and left hand switch controls inside the handlebars. Has anyone done this before? If so how did you go about doing this? What size holes did you drill? Where?
-
are you changing your bars or just want to hide the wires in your existing bars?
-
I just want to hide the wires.
-
check out this article
http://www.bikernet.com/roadkingreport/roadkingreportarch.asp?Article=122002
more info then you will need but should give you some good pointers
-
Thank you that was very helpful. I just finished installing the wires in my handle bars. Not hard at all. Thanks again.
-
glad i could be of help