Custom Vehicle Discussions > CVO™ Street Glide®

Fork Lock 2020 SG

(1/3) > >>

FELIX:
Hi
I need to remove the dash panel that holds the 6 push button switches.  Looks like I have a couple screws and my fork lock to remove.  I have removed the (ign switch.fork lock) on earlier models but they had a button underneath.  How on earth do I remove this on my 2020?

ultra13:
Should be a button on Lt bottom of switch

FELIX:
Fork lock cover removal and install ??

This seems to be a completely different design than the Road Glides, on the Street glides the fork lock switch (Which is only the fork lock NOT the ignition switch), has a flip up cover, does not have any pin underneath like the older lock/switches.  I have removed the two screws out of the ends of the switch housing, and I can get the cover to move around but the switch needs to come off like the older ones did to cleanly remove this cover.  So wondering if anyone has yet tackled this and knows how to perhaps get the switch to separate OR is there another way.  I am, thinking I might have ton remove the housing for the piece in the middle of the gastank... ??

tpb857:
I thought that I had to remove the cover to get to my handlebar clamp, but I was able to slide it back far enough so I didn't have to remove it.  Anyway, I posted here about removing it and someone said that you have to slide the gas tank back a little. 

FELIX:
Wow.  Turns a small job of changing out the switches  or replacing one into a massive job.  Thank you very much for the reply

Navigation

[0] Message Index

[#] Next page