Topic: Comp sprocket lock and crank support (Read 1990 times)

porthole · « **on:** March 16, 2009, 07:57:48 PM »

Seen these yet?

http://www.emcv2.com/accserv/acc-comploc/comploc.htm

http://www.emcv2.com/torqmast/Crank-Outer-Bearing.pdf

http://www.emcv2.com/

DCFIREMANN · « **Reply #1 on:** March 16, 2009, 08:05:24 PM »

NOPE not yet. But I can tell you when I put mine on it is with RED loctite and as much TQ as my 1/2 inch impact will tighten it too. I have never had one that I installed come loose. But I did have a good teacher!!!!!!!

Be Safe

THE DAWG

porthole · « **Reply #2 on:** March 16, 2009, 08:46:53 PM »

I'll stick with the torque spec Mike (TSB), I really don't think the comp nut has enough meat in it to be "worked" with an impact gun.

How about the left side crank bearing?

http://www.emcv2.com/torqmast/Crank-Outer-Bearing.pdf

Author Topic: Comp sprocket lock and crank support (Read 1990 times)

porthole

Comp sprocket lock and crank support

DCFIREMANN

Re: Comp sprocket lock and crank support

porthole

Re: Comp sprocket lock and crank support