www.CVOHARLEY.com

Custom Vehicle Discussions => CVO™ Breakout™ => Topic started by: CHH_Badkarma on January 30, 2017, 09:34:56 PM

Title: Burleigh Bars Fit issue?
Post by: CHH_Badkarma on January 30, 2017, 09:34:56 PM

Hey folks,

Its me, bein a pest again lol. So I have been dieing to put new bars on my 2014 and decided on a set of 16 inch Burleigh high ball bars. So after shootin emails back and forth with them they have mention an issue a customer recently had with the front brake lever bracket not allowing the grip to ride up the bars and lock up, leaving it to free spin so to speak. Has anyone else here had issues with fit and these bars? They sent a vid along with my last exchange of emails and it looks like that little extra bit of the clamp that tapers down to the bars causes too much width clamp wise.

Title: Re: Burleigh Bars Fit issue?
Post by: CHH_Badkarma on February 05, 2017, 07:32:23 PM

Well, seems I may have found parts to fit and make the bar swap work.

http://www.harley-davidson.com/store/chrome-clutch-bracket-and-master-cylinder-reservoir-kit-pa-09-41700330--1

Now I just have to weigh if the mounting cost is worth it. First world problems right? haha