Has anyone used the Sta Bo swingarm bushings? If so, how do you like them?
Along those same lines I remember a thread on front motor mounts. It had something to do with the newer mounts were better than the older mounts, or close. What is the better front bushing to use?
No experience with the swingarm bushings you mention. There were many complaints about the new motor mounts though.
The "old" motor mounts have occasionally broken. Several have had this happen. Some repetitively. I broke a front one once. It happened before the new "A" revision came out.
The revised front motor mount was complained about by many for being too stiff/hard. It apparently transmitted a LOT of vibration back through the bike.
Seem to remember reading of a revision to the revision also. A "B" part number. Don't remember any great lot of discussion about that part though. In the context of "no news is good news" perhaps that means it solved the problems.
There is at least one very good aftermarket alternative though. Check out "Velva" motor mounts. They offer stabilizers too if you want to change it all. For many years they have been perceived as about the best option out there.