Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[porthole]

The night started out good and ended with an "oh chit" and that sinking feeling you get in your gut.

Put a bid (actually a buy it now) on Monday and it was here on Tuesday.

[porthole]

Kit includes just about everything you need to complete the job (except a new case).

Bearing & seal, new sprocket, chain shoe, gaskets etc

[porthole]

Gear Set, pillow block, forks, fork rod and new chain

[porthole]

.

[porthole]

In case you had any doubts as to whether Redline will cling to the gears. ............

The last time I road my bike was near the end of October. Almost halfway through March now and the gears are covered with oil yet.

[porthole]

.

[porthole]

Georges Garage tool to remove the trap door and gear set as an assembly.

2 shorter screws go here into the trapdoor

[porthole]

Longer screws go on the ends and when turned in they apply pressure to the trans case (actually a pin in the case).

This "walks" the trap door and gears out.

On my bike I had a roll pin in the front of the case, so all the tool did there was try and drive into the roll pin and bugger up the screw a bit.

[porthole]

Gear Set on it's way out

screw trying to "push" against he roll pin (right side).

[porthole]

After the gear set is out you are left with the main drive gear and bearing in the case

[porthole]

.

[porthole]

Georges Garage Main Drive Gear & bearing Installer and remover.

The tool came with the thumb screws, but were too hard to work with. Found a couple of stainless bolts laying around

[porthole]

Left side with the remover on the drive gear

[porthole]

"nice" bearing and ready to remove

[porthole]

Set and ready to go