www.CVOHARLEY.com
Custom Vehicle Discussions => 2001 FXDWG2/2002 FXDWG3 => Topic started by: speedydog5 on March 08, 2010, 01:11:30 PM
-
how hard to install drag bars on my 2002 fxdwg3 i bought carlinis do i need to pull off tank etc.do i have to take off wires all the way back to battery area, cause i can,t disconnect at switches at all they are sealed no pins to pull out WTF!!! :( and i want to run them through handlebars and is splicing the only option??
-
Did mine about six years back and we cut the pins and installed new pins the wireing harness is real long and has lot of slack , it runs inside the backbone of the frame if my memeory is correct getting the harness back in the frame is a little pain and pulling the wires in the bars can be also.. take your time and it will work out also try useing weed eater line to fish the wires it works great....
-
Did mine about six years back and we cut the pins and installed new pins the wireing harness is real long and has lot of slack , it runs inside the backbone of the frame if my memeory is correct getting the harness back in the frame is a little pain and pulling the wires in the bars can be also.. take your time and it will work out also try useing weed eater line to fish the wires it works great....
how do i get to the pins the harness does run through the frame but it seems like it goes all the way back to the battery did you remove tank??
-
how do i get to the pins the harness does run through the frame but it seems like it goes all the way back to the battery did you remove tank??
I cut the pin off at the control switches and pulled the wires out of the bars then pulled the harness out of the frame to make some slack we had plenty of wire to pull back into the new bars ... we did not remove the tank look for rubber plug on the end of the backbone thats where we pulled the slack wire back into the frame hope this helps....