My name is Steve many know me by HDWRENCH but long story short run a shop that 95% of what we do is performance work. We make the HD engines run like they should. Our basic little 98 inch kit makes 102-104 hp and tq in the 110-114 range with 9.8.1 comp ratio and a little 37g cam, our basic bagger 114 makes in upper 120's/ hp and tq, My daily ride is a 124 engine that makes 159hp and 163 tq on pump fuel. Idles like a champ, runs on the hottest days in the az heat with no issue. Has run 10.11 at 138 mph at firebird race track( locals will know where that is). We just finished up a 103 cvo ultra up to a 124. Will have a dyno sheet in a few weeks. WE look to build very fast revving, cooler running engines that are high velocity ports, so we do not post huge PEAK numbers Our 114s make in the upper 120 range and the 124 bagger kits make in the 140 range. There are a few names on this board that I know and have had dealings with in the past. Not sure what the policy on advertising is so if the link gets pulled I guess i step over the line. But you can check us out at
www.gmrperformance.com you can few our kits and what we do and the dyno sheets to go along with the kits
Bobber is done and is back in CA with it's new owner the magazine will come out next month.