www.CVOHARLEY.com
CVO Technical => Electronic Toys and Gadgets => Topic started by: JoeVibe on July 29, 2018, 09:26:46 AM
-
I'm selling my Ultra and need to know how to clear the GDO receiver so that the bike I sell can't open my garage door. I unplugged the receiver overnight and it still retained the codes. Does anyone know the secret?
-
1.
Unplug the receiver from the 110 Volt power outlet.
2.
Wait ten seconds.
3.
Press and hold the program button on the receiver. While holding the button down, plug the receiver into the power outlet. The red LED flashes rapidly.
4.
Release the program button. The receiver is now reset, and all memory is erased.
5.
Program the receiver again. See the Receiver and Transmitter Programming section earlier in these instructions.
-
Thanks Scott!