Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1] 2  All

Author Topic: Spark plug anti-seize compound  (Read 3014 times)

0 Members and 1 Guest are viewing this topic.

Aussie

  • Elite CVO Member
  • *****
  • Offline Offline
  • Posts: 827


    • CVO1: FLHXSE3 Hot Citrus
Spark plug anti-seize compound
« on: July 09, 2019, 08:51:29 PM »

On installation of spark plugs service manual states to use Silver Grade anti-seize which I have been using for several years but not the HD branded one.
6. Apply a light coat of SILVER GRADE ANTI-SEIZE (Part
No. 98960-97) to the spark plug threads. Install and tighten
to 12-18 ft-lbs (16.3-24.4 Nm).


What I am using is the Anti-Seize 37617 also in a Silver Grade.
Typical Applications: For easy removal of spark
plugs, cylinder head and exhaust head bolts.


There is also another Anti-Seize 37616 in a Copper Grade.
Typical Applications: Spark plug threads installed
in aluminum, exhaust manifold bolts, engine bolts,
thermostat housing bolts, oxygen sensors, battery
cable connections.


Do you see an advantage in using the Copper grade over the Silver Grade, I am thinking of conductivity between spark plugs and cylinder head threads.
Both are suitable for spark plugs except the copper is for spark plugs screwed into aluminum.
Logged

J.D.

  • Guest
Re: Spark plug anti-seize compound
« Reply #1 on: July 09, 2019, 09:40:29 PM »

I always use a small dab of the silver (not HD re-branded) anti-seize on all plugs and never once had an issue.  And I've changed a heck of a lot of spark plugs over the past few decades.
Logged

grc

  • 10K CVO Member
  • ****
  • Offline Offline
  • Posts: 14216
  • AKA Grouchy Old Fart
    • IN


    • CVO1: 2005 SEEG2
Re: Spark plug anti-seize compound
« Reply #2 on: July 10, 2019, 09:02:31 AM »


Either type will work well on spark plug threads, copper has a higher max temp range but I've never had a problem when using the silver variety.  As for conductivity, not a problem either way.  Don't forget, it's kind of like the old Brylcreem commercials from the dark ages of my youth, a little dab will do ya.  I've seen some folks create problems when they assume if a little bit is good, a lot must be better. ;)

Jerry

Logged
Jerry - 2005 Cherry SEEG  -  Member # 1155

H-D and me  -  a classic love / hate relationship.  Current score:  love 40, hate 50, bewildered 10.

J.D.

  • Guest
Re: Spark plug anti-seize compound
« Reply #3 on: July 10, 2019, 09:25:13 AM »

I typically use the copper stuff where (environmental) corrosion is a concern, like suspension bolts.
Logged

dayne66

  • 2.5K CVO Member
  • **
  • Offline Offline
  • Posts: 4037
    • BC


    • CVO1: '12 Ruby/Typhoon SG
    • CVO2: '15 Superior Blue FLD Switchback
Re: Spark plug anti-seize compound
« Reply #4 on: July 10, 2019, 10:39:59 AM »

I have heard not to use copper......if any gets 'inside' and combusts, the O2 sensors will be fouled. But...if you use very little it should not be a problem either way.
Logged
"The only true wisdom is in knowing you know nothing." Socrates

rayson56

  • 1K CVO Member
  • *
  • Offline Offline
  • Posts: 1831
  • Life's a journey not a destination.
    • WA


    • CVO1: 2018 FLTRXSE Black Earth/Vivid Black (Sold)
    • CVO2: 2011 FLHXSE2 Black Diamond (Traded)
    • CVO3: 2007 FXDSE Red (Sold)
Re: Spark plug anti-seize compound
« Reply #5 on: July 10, 2019, 12:28:39 PM »

Either type will work well on spark plug threads, copper has a higher max temp range but I've never had a problem when using the silver variety.  As for conductivity, not a problem either way.  Don't forget, it's kind of like the old Brylcreem commercials from the dark ages of my youth, a little dab will do ya.  I've seen some folks create problems when they assume if a little bit is good, a lot must be better. ;)

Jerry


Well said as usual Jerry, and I remember those commercials.
I've always used the copper and almost all the tech's at the dealership I work at do as well.
Logged
2010 Dyna Wide Glide
2021 GW Bagger
2018 SERG (Sold)
2011 SESG (Traded)
2007 Dyna Wide Glide CVO (Sold)
2010 Night Rod Special
2007 full custom road king
2006 big dog mastiff
2000 big dog pro 18
1999 big dog pro sport
1991 fxrs full custom
1984 v65 magna

longlast

  • 2.5K CVO Member
  • **
  • Offline Offline
  • Posts: 4055

Re: Spark plug anti-seize compound
« Reply #6 on: July 19, 2019, 07:13:37 PM »

I've used copper for years on all fasteners as well as plugs also on the brake disc pads and the threads of the pad keep pins.  It works good on the exhaust joints as said it handles the heat. It's a compound that only requires a small/ thin amount not to be confused as a grease.
Never have had any issues using copper and plugs are number one on the list of it use.
« Last Edit: July 19, 2019, 07:18:12 PM by longlast »
Logged

Smoketown

  • Senior CVO Member
  • ****
  • Offline Offline
  • Posts: 351
  • www.CVOHARLEY.com
    • PA


    • CVO1: 2013 FLHTCUSE8
Re: Spark plug anti-seize compound
« Reply #7 on: July 20, 2019, 10:40:15 AM »

Copper is copper ... But, there are TWO silvers.

One uses aluminum powder ... The cheap stuff.

The more expensive kind uses nickel powder.

Because so little of it is used, there is no reason not to buy the 'good stuff'.

Think about it ... If the heads are aluminum, why would you use an aluminum-based anti-seize?

Back when Google was new, I searched 'anti-seize' and have since been using copper or nickel exclusively. (I've been using up the 'cheap stuff' on auto lug-nuts and the like.)

Side note - The more expensive compounds typically use a finer mesh powder and more of it ... Check the manufacturers' specs.


Cheers,
Smoketown

Logged

Ironhorse

  • Vendor
  • 2.5K CVO Member
  • *
  • Offline Offline
  • Posts: 4334
    • CA


    • CVO1: 2006 SE Ultra
    • CVO2: 2018 GoldWing DCT Airbag
Re: Spark plug anti-seize compound
« Reply #8 on: July 21, 2019, 03:22:33 PM »

All I know about anti-seize compound is that chit gets on everything, and you can't clean it off.
Logged
"But men are men, the best sometimes forget" Shakespeare, Othello Act 2, Scene 3

Smoketown

  • Senior CVO Member
  • ****
  • Offline Offline
  • Posts: 351
  • www.CVOHARLEY.com
    • PA


    • CVO1: 2013 FLHTCUSE8
Re: Spark plug anti-seize compound
« Reply #9 on: July 21, 2019, 05:15:38 PM »

All I know about anti-seize compound is that chit gets on everything, and you can't clean it off.

And the absolute BEST and WORST of the bunch is military grade with 'moly' ...  Used to put it on the ear-piece of the foreman's phone.

I used to live by the LAX ... Ever eat at Tito's or MaGoos?

Cheers,
Smoketown
« Last Edit: July 21, 2019, 05:17:46 PM by Smoketown »
Logged

Ironhorse

  • Vendor
  • 2.5K CVO Member
  • *
  • Offline Offline
  • Posts: 4334
    • CA


    • CVO1: 2006 SE Ultra
    • CVO2: 2018 GoldWing DCT Airbag
Re: Spark plug anti-seize compound
« Reply #10 on: July 21, 2019, 05:23:27 PM »

And the absolute BEST and WORST of the bunch is military grade with 'moly' ...  Used to put it on the ear-piece of the foreman's phone.

I used to live by the LAX ... Ever eat at Tito's or MaGoos?

Cheers,
Smoketown

I love Tito's Tacos!!!  Where did you live near LAX? My house is in Westchester, just two blocks from LMU.
Logged
"But men are men, the best sometimes forget" Shakespeare, Othello Act 2, Scene 3

Smoketown

  • Senior CVO Member
  • ****
  • Offline Offline
  • Posts: 351
  • www.CVOHARLEY.com
    • PA


    • CVO1: 2013 FLHTCUSE8
Re: Spark plug anti-seize compound
« Reply #11 on: July 21, 2019, 05:44:11 PM »

I love Tito's Tacos!!!  Where did you live near LAX? My house is in Westchester, just two blocks from LMU.

Two all meat burritos with cheese please!  The Avocado Cha-Shu burgers at MaGoos were the best!

Used to live over by Emerson Manor Elementary.

Cheers,
Smoketown
Logged

bakon

  • Elite CVO Member
  • *****
  • Offline Offline
  • Posts: 573
    • PA


    • CVO1: 2014 CVO Limited "Wicked"
Re: Spark plug anti-seize compound
« Reply #12 on: September 08, 2019, 07:54:08 PM »

Cheap silver for 20 years. No problems. Mine is a stick, little dab on one spot. Threads will spread it when screwed in.
Logged
Will

2018_FLTRXSE

  • 1K CVO Member
  • *
  • Offline Offline
  • Posts: 2227
  • Wait 6 months?... YES it was worth the wait!
    • HI


    • CVO1: 2018_FLTRXSE, Gunship Grey, (Delivered July 28, 2018... after almost 9 )
    • CVO2: 2001_FLTRSEI, Grey/Black/Silver w/Hannigan Hack and a blast to ride.
    • CVO3: 2012_FLTRXSE, Maple/Black (Delivered 1/20/2012 - Traded 10/25/2017)
Re: Spark plug anti-seize compound
« Reply #13 on: October 10, 2019, 02:47:25 PM »

All I know about anti-seize compound is that chit gets on everything, and you can't clean it off.

How true this is!

Much truth to the difference in anti seizes.as well. Copper will potentially foul 02 sensors and clog catalytic converter (s) just use enough to lightly coat the threads. All you want to do is prevent the dissimilar metals from getting stuck together.
Logged

No more Hawaii HOG Rally... ask HOG why...

bigchuck

  • Elite CVO Member
  • *****
  • Offline Offline
  • Posts: 859
  • www.CVOHARLEY.com
    • TX


    • CVO1: 2015 Limited
Re: Spark plug anti-seize compound
« Reply #14 on: October 12, 2019, 11:57:31 AM »

Over thinking it. Use either one. Just don't use too much and you'll be fine.
Logged
2015 CVO Limited
Long Ride Shield
Fullsac dx w/2"cores, TTS tuned by Wolfgang
Super Shox
Pages: [1] 2  All
 

Page created in 0.185 seconds with 25 queries.