Remove the torx screws that hold the bag side connector together.
I had a right angle drill for making the holes from inside the bag so I could put the outlet as close to the factory plug as possible. If you don't, mark the out side and drill
Install rubber grommets (supplied with power outlet) into holes you just drilled.
Remove plugs and pin retainer from bag side quick disconnect.
Now for the most complicated part of the install. Find or buy some additional wire. Install terminals to both ends. Remember, you need the whole harness that came with the outlet to run on the bike side.
Install wires into bag connector. make sure polarity lines up with the one on the bike side connector
I don't care for spade connectors, so I soldered the connection to the power outlet.
Install supplied mounting hardware and reinstall bag.
Done.
Should have been a factory piece though