Please login or register.

Login with username, password and session length
Advanced search  
Pages: 1 2 [3]  All

Author Topic: R&R cycle crank on 117  (Read 5491 times)

0 Members and 1 Guest are viewing this topic.

prodrag1320

  • AMRA & AHDRA P/D record holder
  • Vendor
  • Elite CVO Member
  • *
  • Offline Offline
  • Posts: 917
Re: R&R cycle crank on 117
« Reply #30 on: December 29, 2018, 07:58:36 AM »

Looking for clarification on the Timken bearing install. The guy is planning on using the Jim’s set up. Someone on here said that’s not the right way to do it. Can you clarify what I should be asking please? Is the Jim’s Timken design bad or is it how it’s installed I should be worried about?

 the JIMS insert is the way to do it.theres talk about improper install on alignment or even some places that make their own off set inserts.we`ve installed 100`s of JIMS inserts,checking every case for misalignment,worse we`ve ever seen was .0008,no where near the point of needing any special insert made and still way better than 1 or 2 lefties on the sprocket side. most are within .0005 or less

1roadking

  • Senior CVO Member
  • ****
  • Offline Offline
  • Posts: 393
  • www.CVOHARLEY.com
    • NH


    • CVO1: 2016 SE Streetglide
Re: R&R cycle crank on 117
« Reply #31 on: February 05, 2019, 09:08:46 PM »

Scheduled this work for this month:)
Logged
Pages: 1 2 [3]  All
 

Page created in 0.115 seconds with 21 queries.