www.CVOHARLEY.com

CVO Technical => Electronic Toys and Gadgets => Topic started by: iceesceu5 on May 01, 2013, 01:50:33 PM

Title: SE Turn Signal Module
Post by: iceesceu5 on May 01, 2013, 01:50:33 PM

Has anyone used the SE Ultra Tour-Pak turn signal module from ride time technology? Thinking about ordering but would like to hear from those that have used the product good---or bad. Thanks

Title: Re: SE Turn Signal Module
Post by: Vyscera on May 01, 2013, 01:58:43 PM

I bought a TP second hand and went through Ride time for a Y-harness. Excellent customer service, clean harness, and quick turn around. If all their work is as good, you cant go wrong.

Title: Re: SE Turn Signal Module
Post by: JoeVibe on May 01, 2013, 02:10:51 PM

I bought both Ride time harnesses (to make the corner lights and side marker lights work as turn signals) and I'm very happy with their products and the results. The install was pretty straight forward, the instructions were well written, and my back lights really get attention on the road.

Title: Re: SE Turn Signal Module
Post by: iceesceu5 on May 02, 2013, 10:26:53 AM

Thanks, I got em ordered last night. Looking forward to some added visibility.

Title: Re: SE Turn Signal Module
Post by: 1abastarsmda on May 03, 2013, 01:42:33 AM

I had them on my last bike and there were a must have on this one.  The guys I ride with put them on theirs too.  Excellent addition to your bike.  I did the side lights on the tourpak to blink as turn signals also.  The hardest part installing them is putting the rubber bushing back in where you run the wires into the tourpak.  After doing a few of them, even that got easier.

Title: Re: SE Turn Signal Module
Post by: JoeVibe on May 03, 2013, 07:59:48 PM

I tried to get the connector through the hole without taking the grommet out and couldn't get it done so I pulled it out and ran the wires. Then I used a little WD-40 on the grommet and it went right back in place.