Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1] 2  All

Author Topic: Stand/lift  (Read 2795 times)

0 Members and 1 Guest are viewing this topic.

Tony Smith

  • .
  • Full CVO Member
  • ***
  • Offline Offline
  • Posts: 164
    • VA


    • CVO1: 2009 FLTRSE3
    • CVO2: 2017 FLHXSE
    • CVO3: 2019 FLHXSE
Stand/lift
« on: July 02, 2019, 06:04:35 AM »

I’m looking at buying a lift, anyone have experience or advice here?  The one I want is
https://www.apluslift.com/products/new-apluslift-mt1500x-1500lb-air-op-motorcycle-lift-table-with-side-extension
The install instruction tell you in bold red print about 10 times throughout the instruction to NEVER RIDE ONTO THE LIFT, ALWAYS PUSH IT.  If I get it it will take my regular parking spot in the garage, so I’ll have to drive up on it. I’m assuming the abundance caution is just for their insurance reasons.
Logged
2019 FLHXSE Black Forest/Wineberry
2017 FLHXSE Black/Orange FOR SALE
2012 FLTRU Black SOLD
2009 FLTRSE3 Silver SOLD
2007 FXSTC Black Cherry/Pewter SOLD
1988 Suzuki Katana 750 SOLD
1994 Kawasaki KX250 SOLD
1974 Honda 500 (crashed and left in a ditch somewhere)

Joel

  • 1K CVO Member
  • *
  • Offline Offline
  • Posts: 1019
    • WA


    • CVO1: 2015 CVO LIMITED
Re: Stand/lift
« Reply #1 on: July 02, 2019, 08:01:32 AM »

I think the main reason for that is the platform may be too narrow and if you don't get your foot down just right your now a few inches higher and may tip over.
I should be easy to push the bike up the ramp, secure it than sit on it so you can judge the distance.
Logged
Always keep 2 feet away from your shadow

Ironhorse

  • Vendor
  • 2.5K CVO Member
  • *
  • Offline Offline
  • Posts: 4334
    • CA


    • CVO1: 2006 SE Ultra
    • CVO2: 2018 GoldWing DCT Airbag
Re: Stand/lift
« Reply #2 on: July 02, 2019, 08:34:44 AM »

Can you install a mirror in the garage and angle it in such a way to see how the front tire aligns with the wheel chock?
Logged
"But men are men, the best sometimes forget" Shakespeare, Othello Act 2, Scene 3

chaos901

  • Senior CVO Member
  • ****
  • Offline Offline
  • Posts: 480
  • FLHRSEI.ORG

    • CVO1: 2000 SE Road Glide
    • CVO2: 2008 SEUC3
    • CVO3: 2010 SEUC5
Re: Stand/lift
« Reply #3 on: July 02, 2019, 09:38:19 AM »

I always ride mine up on the lift, now I also have fairly long legs so reaching down is not an issue.
Logged

mark

  • Guest
Re: Stand/lift
« Reply #4 on: July 02, 2019, 09:50:32 AM »

All these table lifts are basically the same (except for Handy, which is made in the US) and are made in China, probably in the same factory.  I have one similar to the pic you posted, its rated for 1,000 lbs. and I've ridden onto the lift for years.  As long as you have the side pieces installed (so you have a place to put your feet) you'll be fine.  I imagine the admonishment about pushing the bike onto the lift is a liability thing.  Trying to push a 900 lb. bike up the ramp by yourself is going to be more precarious than riding onto the lift, IMO. 

Also, I initially had the wheel clamp type chock for the front wheel; however, after riding up, you have to get off the bike, continue to balance it with one hand, while tightening the clamp with the other hand.  To make it easier, I mounted my Bike Pro chock to the lift, so now when I ride up, the wheel is locked in place so I can just get off of the bike.  BTW, you're going to love having a table lift...so easy to detail and service your bike.  Your knees will really appreciate it.       
Logged

Ironhorse

  • Vendor
  • 2.5K CVO Member
  • *
  • Offline Offline
  • Posts: 4334
    • CA


    • CVO1: 2006 SE Ultra
    • CVO2: 2018 GoldWing DCT Airbag
Re: Stand/lift
« Reply #5 on: July 02, 2019, 09:55:24 AM »

Trying to push a 900 lb. bike up the ramp by yourself is going to be more precarious than riding onto the lift.

Spot on.
Logged
"But men are men, the best sometimes forget" Shakespeare, Othello Act 2, Scene 3

mjb765

  • 5k CVO Member
  • ***
  • Offline Offline
  • Posts: 6747

    • CVO1: 2011 FLHXSE--sold
    • CVO2: 2015 FLHXSE--sold
    • CVO3: 2018 FLTRXSE
Re: Stand/lift
« Reply #6 on: July 02, 2019, 10:16:50 AM »

The problem is having somewhere to put you feet down while riding up on to the lift. Or you could sink it in....
Logged

Tony Smith

  • .
  • Full CVO Member
  • ***
  • Offline Offline
  • Posts: 164
    • VA


    • CVO1: 2009 FLTRSE3
    • CVO2: 2017 FLHXSE
    • CVO3: 2019 FLHXSE
Re: Stand/lift
« Reply #7 on: July 02, 2019, 10:23:38 AM »

The problem is having somewhere to put you feet down while riding up on to the lift. Or you could sink it in....

Wow. That’s cool. I want that garage
Logged
2019 FLHXSE Black Forest/Wineberry
2017 FLHXSE Black/Orange FOR SALE
2012 FLTRU Black SOLD
2009 FLTRSE3 Silver SOLD
2007 FXSTC Black Cherry/Pewter SOLD
1988 Suzuki Katana 750 SOLD
1994 Kawasaki KX250 SOLD
1974 Honda 500 (crashed and left in a ditch somewhere)

dayne66

  • 2.5K CVO Member
  • **
  • Offline Offline
  • Posts: 4037
    • BC


    • CVO1: '12 Ruby/Typhoon SG
    • CVO2: '15 Superior Blue FLD Switchback
Re: Stand/lift
« Reply #8 on: July 02, 2019, 11:06:07 AM »

I have the same lift....it works great!

I considered sinking it into the floor...but.....did not want to lose 6" of  lift height or the use of the spot for 4 wheel vehicles in some positions.

As far as riding the bikes up.....I always do. Once I had a bit of moisture on one boot, slipped a bit and very nearly had a mishap. My solution was to get some "skate board sandpaper stick-on grippy stuff" and put it on the side ramps and back half of the sides....basically anywhere your feet may touch down. I also ran a strip up the center where the tires contact.

I did not have the room to store it on the floor and get both bikes and two daily drivers in the garage.....so I stood it up. A couple pieces of angle iron lag bolted to the floor joists above, and a cheap chain fall and it stands along the wall taking up very little room. When hoisting it up I put a piece of upside-down rubber backed carpet under the feet to help is slide on the floor.

I just made some brackets to store the ramps on the wall also.....not painted, installed or photoed yet
Logged
"The only true wisdom is in knowing you know nothing." Socrates

Tony Smith

  • .
  • Full CVO Member
  • ***
  • Offline Offline
  • Posts: 164
    • VA


    • CVO1: 2009 FLTRSE3
    • CVO2: 2017 FLHXSE
    • CVO3: 2019 FLHXSE
Re: Stand/lift
« Reply #9 on: July 02, 2019, 11:37:01 AM »

I have the same lift....it works great!

I considered sinking it into the floor...but.....did not want to lose 6" of  lift height or the use of the spot for 4 wheel vehicles in some positions.

As far as riding the bikes up.....I always do. Once I had a bit of moisture on one boot, slipped a bit and very nearly had a mishap. My solution was to get some "skate board sandpaper stick-on grippy stuff" and put it on the side ramps and back half of the sides....basically anywhere your feet may touch down. I also ran a strip up the center where the tires contact.

I did not have the room to store it on the floor and get both bikes and two daily drivers in the garage.....so I stood it up. A couple pieces of angle iron lag bolted to the floor joists above, and a cheap chain fall and it stands along the wall taking up very little room. When hoisting it up I put a piece of upside-down rubber backed carpet under the feet to help is slide on the floor.

I just made some brackets to store the ramps on the wall also.....not painted, installed or photoed yet
That is slick. What’s your experience with the front wheel clamp that comes with the lift?  Does it work well for single person loading or would you recommend something like the CONDOR PS-1500 Pit Trailer-Stop?
https://www.amazon.com/dp/B01B3JZWDQ/ref=cm_sw_r_cp_api_i_8N3gDb526JXS3
Logged
2019 FLHXSE Black Forest/Wineberry
2017 FLHXSE Black/Orange FOR SALE
2012 FLTRU Black SOLD
2009 FLTRSE3 Silver SOLD
2007 FXSTC Black Cherry/Pewter SOLD
1988 Suzuki Katana 750 SOLD
1994 Kawasaki KX250 SOLD
1974 Honda 500 (crashed and left in a ditch somewhere)

dayne66

  • 2.5K CVO Member
  • **
  • Offline Offline
  • Posts: 4037
    • BC


    • CVO1: '12 Ruby/Typhoon SG
    • CVO2: '15 Superior Blue FLD Switchback
Re: Stand/lift
« Reply #10 on: July 02, 2019, 11:54:34 AM »

That is slick. What’s your experience with the front wheel clamp that comes with the lift?  Does it work well for single person loading or would you recommend something like the CONDOR PS-1500 Pit Trailer-Stop?
https://www.amazon.com/dp/B01B3JZWDQ/ref=cm_sw_r_cp_api_i_8N3gDb526JXS3
I have had no trouble using the front wheel clamp....I have marks that are about 3/4" wider than our tires (my FLHXSE3 and the Wife's FLD)...and with the grip it's safe and easy to do a little maneuvering. I get the front tire in.....Shut off engine, leave in gear.....out with the jiffy stand.....let lean to the left.....put on front straps ...
Logged
"The only true wisdom is in knowing you know nothing." Socrates

mark

  • Guest
Re: Stand/lift
« Reply #11 on: July 02, 2019, 05:35:31 PM »

The problem is having somewhere to put you feet down while riding up on to the lift. Or you could sink it in....

Wish I'd thought about doing this when I built my house...
Logged

mjb765

  • 5k CVO Member
  • ***
  • Offline Offline
  • Posts: 6747

    • CVO1: 2011 FLHXSE--sold
    • CVO2: 2015 FLHXSE--sold
    • CVO3: 2018 FLTRXSE
Re: Stand/lift
« Reply #12 on: July 02, 2019, 05:46:40 PM »

Wish I'd thought about doing this when I built my house...

My garage is 65yrs old....I had someone cut the concrete and dig down a bit. Took 2 guys a few hours and some cement. the next day I slid the lift in the hole. It's never too late.
Logged

Tony Smith

  • .
  • Full CVO Member
  • ***
  • Offline Offline
  • Posts: 164
    • VA


    • CVO1: 2009 FLTRSE3
    • CVO2: 2017 FLHXSE
    • CVO3: 2019 FLHXSE
Re: Stand/lift
« Reply #13 on: July 02, 2019, 07:14:41 PM »

My garage is 65yrs old....I had someone cut the concrete and dig down a bit. Took 2 guys a few hours and some cement. the next day I slid the lift in the hole. It's never too late.

What a great idea. Do you think my landlord would mind?  Haha
Logged
2019 FLHXSE Black Forest/Wineberry
2017 FLHXSE Black/Orange FOR SALE
2012 FLTRU Black SOLD
2009 FLTRSE3 Silver SOLD
2007 FXSTC Black Cherry/Pewter SOLD
1988 Suzuki Katana 750 SOLD
1994 Kawasaki KX250 SOLD
1974 Honda 500 (crashed and left in a ditch somewhere)

mjb765

  • 5k CVO Member
  • ***
  • Offline Offline
  • Posts: 6747

    • CVO1: 2011 FLHXSE--sold
    • CVO2: 2015 FLHXSE--sold
    • CVO3: 2018 FLTRXSE
Re: Stand/lift
« Reply #14 on: July 02, 2019, 08:46:07 PM »

What a great idea. Do you think my landlord would mind?  Haha

LOL....yeah maybe
Logged
Pages: [1] 2  All
 

Page created in 0.246 seconds with 25 queries.