Hey Guys,
Sorry about the delay in responding. We(I) have been out of the office at the Indy Powersports Expo since Wednesday of last week. Thanks for the questions and the consideration of our product. We are having fun with it and enjoying the responses of people having good luck with it. Let's address a couple of questions that were specific first. With regards to a cam change the answer is no, you don't have to send the ECM back to us. One of our first testers, and subsequently, endorsers of the product was Dan Thompson of Hotshot Motorworks. He got a unit and installed it on his bone stock '09 Street Glide and rode it for evaluation. He then came back and installed a full exhaust, .615" Crane cams, a 103" kit and a set of his ported heads. He went through the start up procedure again, confirmed that the system did, in fact, re-adjust itself for the new combination and left on it for Fla. Only after this test would he endorse the system. The system has a 20% cubic inch displacement window and if you change the numeric value of the injectors we need it back. All you have to do is get it to us and we re-cal for free. Most of the time the increase in displacement and an injector change go hand in hand so that gets it done. Thanks again and feel free to call if you have any questions before I get a chance to get over here and answer them.
Brian