www.CVOHARLEY.com

Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: cometic head gasket question  (Read 732 times)

0 Members and 1 Guest are viewing this topic.

panhead1

  • Full CVO Member
  • ***
  • Offline Offline
  • Posts: 226
cometic head gasket question
« on: July 21, 2010, 02:01:33 PM »
Was curious about the little rivot holding the 3 peice spring gasket together.  Do you guess just leave it or cut that part off?  I am guessing there is no real up or down side to the gasket either is there?
Logged

HD Street Performance

  • Vendor
  • 2.5K CVO Member
  • *
  • Offline Offline
  • Posts: 3119
Re: cometic head gasket question
« Reply #1 on: July 21, 2010, 02:08:36 PM »
Used to cut one side when they intruded into the pushrods, no issues. But today why mess with it?
Logged

panhead1

  • Full CVO Member
  • ***
  • Offline Offline
  • Posts: 226
Re: cometic head gasket question
« Reply #2 on: July 21, 2010, 02:17:49 PM »
ok thanks was just curious.  Hadn't used them before.  didn't feel like screwing stuff up.  Tired of taking this motor apart over and over.  I got the 10.5 pistons and cylinders last night installed them today and did the clay test while i was at it.  Thought i might have to worry.  Man you have all kinds of room still before anything even gets close to touching.  I was surprised.  So hopefully this afternoon i will be back on the road again. 
Logged
 

Page created in 0.127 seconds with 22 queries.