Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: Rinehart slip on help  (Read 719 times)

0 Members and 1 Guest are viewing this topic.

Designflaw

  • Senior CVO Member
  • ****
  • Offline Offline
  • Posts: 328
  • www.CVOHARLEY.com
    • KY

    • CVO1: 2017 CVO Street Glide
Rinehart slip on help
« on: May 06, 2019, 09:02:50 PM »

Bought some slip ons to get through the summer, and they are anything but slip on.

Working on the right side, needed some persuasion. Now it needs a half inch twist and is not budging. Thought about taking it off and trying again and... not budging. I can't persuade it off the same as on which was 2x and malot.

So, how best do I resolve this, strap wrenches? If it has to come off, how best to knock it back off?

How do I help the other side move easier

Sent from my SM-G955U using Tapatalk

Logged
2017 FLHXSE CVO Sunburst Orange/Starfire Black
Performance: HP 99 TQ 121
Stage II = HD Torque Cam SE8-447
Rinehart Slimline, 4" Cans
HD Tuner w/ Wideband module
Screaming Eagle Front Fork internals, Tuned Rear
 
Appearance:
Blacking out all chrome and bolts. (Work in progress)
Custom color matched carbon fiber parts
HD Passing Lamps and LED lamps

Para Bellum

  • Si vis pacem, para bellum.
  • 1K CVO Member
  • *
  • Offline Offline
  • Posts: 1943

    • CVO1: '07 Canyon Copper FXSTSSE, '08 Crystal Copper SEUC
    • CVO2: '11 Slate/Blk SERGU, '18 Twisted Cherry RGU
Re: Rinehart slip on help
« Reply #1 on: May 06, 2019, 10:41:39 PM »

Spray some penetrating oil, like WD-40 etc., on to the header/muffler junction.  Aim into the muffler so it gets inside the junction.  Give it a few minutes to "creep" in, then twist or rotate the muffler.

If this doesn't loosen it enough, hold the exit end of the muffler with one hand and the header at the muffler/header junction.  Gently raise and lower the end of the muffler while holding the header so it doesn't move.  Works better if a helper is available to pull on the muffler while raising/lowering.

I always put some lubricant on the end of the header before installing or removing the mufflers.  Good luck.
Logged
If you want peace, prepare for war.
 

Page created in 0.231 seconds with 25 queries.