Topic: Garage Door Transmitter Not Working?? This could be why.. (Read 1024 times)

Flying Ace · « **on:** May 10, 2009, 07:40:04 PM »

Couldn't figure out why it wouldn't work, tested voltages, hi beam, low beam all good then I spotted the wires on the Transmitter connector were crossed, Black and White!!

Pulled the pins and reversed them now all works fine! Quality control at it's finest.

rheiner · « **Reply #1 on:** May 10, 2009, 10:58:05 PM »

Speaking of quality control, I couldn't figure out why I had such limited CB range on my SEUC4. I took the bike to a professional two way radio shop and after doing diagnostics for a while, they determined the CB and AM/FM antennas were installed in the wrong socket. They switched them and I was good to go on the radios.

Randall

REGGAB · « **Reply #2 on:** May 10, 2009, 11:23:41 PM »

Ken (Hogbreath) you need to read this thread. I never thought to check for this when we were looking at your garage door transmitter.

hogasm · « **Reply #3 on:** May 11, 2009, 05:40:59 PM »

Can it be plugged in backwards

Some plugs are reversible, wouldn't think that Harley would use one though

Flying Ace · « **Reply #4 on:** May 11, 2009, 05:47:57 PM »

Nope, it's a 4 wire deutsch connector that only goes together one way. Whomever manufactured the Transmitter connecter goofed up. How many times is the question..

Author Topic: Garage Door Transmitter Not Working?? This could be why.. (Read 1024 times)

Flying Ace

Garage Door Transmitter Not Working?? This could be why..

rheiner

Re: Garage Door Transmitter Not Working?? This could be why..

REGGAB

Re: Garage Door Transmitter Not Working?? This could be why..

hogasm

Re: Garage Door Transmitter Not Working?? This could be why..

Flying Ace

Re: Garage Door Transmitter Not Working?? This could be why..