Topic: SE Can Tips install on the stock ’09 FLTRSE3 Cans (Read 3266 times)

NVWLDTHG · « **Reply #15 on:** October 25, 2009, 10:23:19 PM »

Tighten down the outer chrome counter sunk screws (six per side, including the original three)

NVWLDTHG · « **Reply #16 on:** October 25, 2009, 10:24:05 PM »

Then, tighten down the four inner black oxide screws.

NVWLDTHG · « **Reply #17 on:** October 25, 2009, 10:24:56 PM »

I’d recommend thread lock be applied to all screws. But, get everything tight in place and then back out one screw at a time to apply the thread lock compound.

NVWLDTHG · « **Reply #18 on:** October 25, 2009, 10:25:49 PM »

Where is she? I dare her! She probably was hired under a Federal Grant for Seat Belt Enforcement. It’s way outside of her job description. This will be harassment!

NVWLDTHG · « **Reply #19 on:** October 25, 2009, 10:26:30 PM »

Some reflector? They don’t work in the dark?

Oh well, now to get the fullsacs and the blasted things centered!

LarryB · « **Reply #20 on:** October 26, 2009, 08:00:36 AM »

Glad i saw the title before I replied, softens the blow.
get out the fishing line and WD-40
good job on the install

Author Topic: SE Can Tips install on the stock ’09 FLTRSE3 Cans (Read 3266 times)

NVWLDTHG

Re: SE Can Tips install on the stock ’09 FLTRSE3 Cans

NVWLDTHG

Re: SE Can Tips install on the stock ’09 FLTRSE3 Cans

NVWLDTHG

Re: SE Can Tips install on the stock ’09 FLTRSE3 Cans

NVWLDTHG

Re: SE Can Tips install on the stock ’09 FLTRSE3 Cans

NVWLDTHG

Re: SE Can Tips install on the stock ’09 FLTRSE3 Cans

LarryB

Re: SE Can Tips install on the stock ’09 FLTRSE3 Cans