480Ruger, I made a flat metal plate which attaches to the K&N air filter in three places, at the air filter mouting studs( I used the stock mounting plate as a template ).Because of the hump in the middle of the K&N filter I had to use longer screws and some small spacers,and of course drill a hole in the middle for the center bolt. I also had to use the air cleaner service gasket (part no. 29591-99 which costs $11.35) to make sure that the original football cover (09SEUC) was a snug fit. When drilling the center hole I made sure that the metal plate covered most of the hump in the center of the air filter that the large air filter cover bolt goes thru so the metal plate could prevent tension on the center part of the air filter that is caused when you tighten the large center bolt. It all feels very solid. Although I do not have too many miles on since I put the plate on I feel very confident that center of the K&N air filter will not pull out again. Sorry for no pictures, but by the time that crossed my mind it was all back together. I had an earlier post where I adapted the stock air filter plate to the K&N filter and stock football cover, but it stuck out about 3/4 of an inch farther and lowered the cover a little. I feel that the way I have it now is much better, although using the stock air filter cover mounting bracket was a lot easier. CAHDBIKER
Author
Topic: K&N high flow custom intake assembly (Read 802 times)