Topic: A good video on how to change cams. (Read 1179 times)

cvobiker · « **Reply #1 on:** July 17, 2011, 06:05:54 PM »

Not Bad,,, In fact a little more detail then the Short Block Charlie Top End Instructional videos...

thanks for sharing the link

guppytrash · « **Reply #2 on:** July 17, 2011, 07:31:53 PM »

Thanks

cahdbiker · « **Reply #3 on:** July 17, 2011, 09:46:42 PM »

Fireguy, thanks for the great video. I noticed on some other videos they show the use of a hydraulic press to remove and replace cams. Is that on gear drive cams? Just wondered if anybody knew. Thanks in advance. CAHDBIKER

timtoolman · « **Reply #4 on:** July 18, 2011, 10:05:37 AM »

In 2000 to 2006 twin cam 88 engines except 06 dynas the cam bearings were pressed on and off in the cam plate and cams pressed in the bearings with special tools and yes gear drives are pressed on and off also.

cahdbiker · « **Reply #5 on:** July 19, 2011, 09:37:46 AM »

Thanks. CAHDBIKER

Quote from: timtoolman on July 18, 2011, 10:05:37 AM

In 2000 to 2006 twin cam 88 engines except 06 dynas the cam bearings were pressed on and off in the cam plate and cams pressed in the bearings with special tools and yes gear drives are pressed on and off also.

Author Topic: A good video on how to change cams. (Read 1179 times)

Fireguy

A good video on how to change cams.

cvobiker

Re: A good video on how to change cams.

guppytrash

Re: A good video on how to change cams.

cahdbiker

Re: A good video on how to change cams.

timtoolman

Re: A good video on how to change cams.

cahdbiker

Re: A good video on how to change cams.