Topic: License plate bracket and frames (Read 844 times)

Canman · « **on:** February 02, 2013, 12:07:06 PM »

The problem with the Canadian license plates ( at least in Alberta) is they are bigger than the American plates, therefore the aftermarket or accesory brackets and frames that hold them are not the proper size. We have to cut down the plates quite a bit to make them fit. Are there any that are made for the Canadian oversized license plates?

dayne66 · « **Reply #1 on:** February 02, 2013, 12:19:20 PM »

Heritage HD in Edmonton used to have a Canadian sized plate frame, but, it's not a nice curved, fender hugger. If I remember right, it was made in BC and was around $180.
This is one I found in Washington...it 'shows' 3 5/8" x 6 3/4"...with a bit of trimming my BC plate fits and doesn't cut off any(much) pertinent info.

Gettin' rid of that reflector is on the winter to do list.

Author Topic: License plate bracket and frames (Read 844 times)

Canman

License plate bracket and frames

dayne66

Re: License plate bracket and frames