Thank you Hogsdownunder and dlaws. I guess I need to track down a 6pt 1 5/16" socket. Thanks for the information on the internal hex side too; I wasn't sure what size that was either, other than really fricken' big!
As for my project, it's coming along well. I've got my bars fully done, all wiring and lines are run. I need to fill/bleed the front brake and hydraulic clutch. Most of the other small little things I was planning have been done too.
I need to get the rear tire off so I can pull the splash guard and remove the Power Commander V that the previous owner installed. Once I'm back to just the stock ECM, I'll be having a custom dyno tune done in the spring, next year. Weather is getting a bit too cold to really get a great tune.
I decided that since I had my tank off for the bar install and other wiring stuff, it was a good time to install a Shotgun Shock, since the wiring needs to be run to the horn bracket for the switches.
Hopefully that arrives today or tomorrow.
Anyway, thanks again, and I'll get a small build thread posted up once I get everything completed.