I am adding LED's to the new bike. I have already installed the fairing ACC switch in the middle location next to the factory AUX light switch, and it controls the auxiliary power connector (black) under the left side cover just above the ECM connector (gray) and just below the battery tender plug. The issue I am having is that I cannot find any kind of mating connector for this that would allow me to simply plug in and have bare wires to connect to the LED's. I know that it is a 4-pin Molex plug (only 2 pins are in place) and not a Deustch plug. I cannot find any wiring kits that would connect to this plug (plenty of kits for up to 2016, but nothing for 2017). The only thing that comes close is an HD wiring upgrade kit that connects to an un-switched connector under the right side cover. I am getting ready to snip the damn connector off and solder in my own leads, but was really hoping to leave it plug and play. Any thoughts or ideas?