Topic: dyno results on the 525 cam (Read 1069 times)

GMR-PERFORMANCE · « **on:** October 10, 2007, 03:40:38 PM »

We supplied a kit to a customer in AL with a 98 inch kit our cnc heads with a 1.9 int and a 1.625 ex compression was set to 9.7 . It has a CV 44 carb and a DTT ign system with hooker trouble maker 2-2 pipes. I have this cam in a 107 that will be done soon and once I have that dyno sheet i will post it. It is only a gear drive, and does not look like it will go chain. Any ways the little stick has pulled some great numbers for being so mild.

nidan · « **Reply #1 on:** October 11, 2007, 06:52:26 AM »

Wow Steve , that's looking great! Thanks for posting!

After warranty is up I'm thinking about the 525 or the Andrews TW 54 which looked to have similar numbers but a bit higher lift for my 103 .

Talon · « **Reply #2 on:** October 11, 2007, 09:06:14 AM »

Nice TQ! no dips, 100 ft lb at 2.5, that'll pull you out of the hole.

Author Topic: dyno results on the 525 cam (Read 1069 times)

GMR-PERFORMANCE

dyno results on the 525 cam

nidan

Re: dyno results on the 525 cam

Talon

Re: dyno results on the 525 cam