Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Dan_Lockwood]

Well I finally got the frame etc today from Milwaukee Iron.  It was delivered today to me at work.  Here are a few pictures.


This is with the shrink wrap removed at work.


This is after I arrived at home.


This is it after I put the tires on it and a bit of the other goodies I have for it.


This gives you an idea of the frame and how it cradles the crankcase on the bottom.


This is just the other side.

Well there you have it, the start of my new project.  I think with 113" and a rated rear wheel hp of 120, it should move right along.

I'll update everyone as I get more done to it.

First though I'm going to remove the rear upper turn signal brackets and then remove the left rear lower plate bracket.  I'll be doing a tail light and plate mount on the top of the rear fender as in the "old" days.  I'm going to have turn signals but I'm not sure yet what I'll do to keep them from sticking out like a sore thumb.

I'm always open to suggestions if anyone has any ideas.

Later...

    

[sadunbar]

This ones going to be fun to watch!  Good luck!   I'm sure you're going to have a great result. 

[naitram]

get a plate frame that has LED signals built in

[Keithincda]

Sweeeeeeeet! Look forward to the updates...