Any one have advice on removing the fairing I am installing a new radio.
Thanks,
Dave
See 2lanes post concerning another thread - lots of good tips, especially his idea to use old socks over the spot lights. I have a couple more suggestions that make it easier for me:
1. Remove windshield first.
2. Remove two bottom screws next.
3. Remove two screws near the speakers last.
4. Tilt fairing forward, reach in and disconnect headlight wiring connector.
Installation:
1. Connect headlight wire connector.
2. Loose install center w/shield screw.
3. Loose install two bottom screws (hardest to align, easier if these are done first).
4. Loose install two screws near speaker.
5. Install windshield and windshield screws, do not overtighten.
6. Tighten two bottom screws.
7. Tighten two screws near speakers.
The holes and anchors do not line up perfectly, and loose installing everything first helps get all of the screws started straight without crossthreading.
Jerry